Table of Contents
Advertisement
Figure 57. Removing the Riser 2c
Next steps
Replace the expansion card
Installing the expansion card risers
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the air
shroud.
4. If removed, install the expansion cards into the expansion card risers.
Steps
1. For Riser 1, release the blue latch and holding the touch points, align the expansion card riser with the connector and the
riser guide pin on the system board. Lower the expansion card riser into place until the expansion card riser connector is fully
seated in the connector.
60
Installing and removing system components
risers.
Safety
instructions.
Before working inside your
system.
Hide quick links:
Advertisement
Table of Contents
