Installing the left control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the front
bezel.
4.
Remove the backplane
5.
Remove the air
shroud.
Steps
1. Route the control panel cable through the cable clip, the guide slots in the system and connector on system board.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Close and secure the cable guiding latch.
3. Align and insert the left control panel assembly in the slot on the system.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the left control panel assembly to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 94. Installing the left control panel
Next steps
1.
Replace the air
shroud.
2.
Replace the backplane
3.
Replace the front
bezel.
4. Follow the procedure listed in
Removing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
90
Installing and removing system components
Safety
instructions.
Before working inside your
cover.
cover.
After working inside your
Safety
instructions.
system.
system.