Intrusion Switch Module; Removing The Intrusion Switch Module; Installing The Intrusion Switch - Dell EMC XC Core XC450 Installation And Service Manual

Next steps
1. Replace the air shroud.
2. Follow the procedure listed in

Intrusion switch module

This is a service technician replaceable part only.

Removing the intrusion switch module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
Steps
1. Disconnect and remove the intrusion switch cable from the connector on the system board.
Observe the routing of the cable as you remove it from the system.
2. Using the Phillips #1 screwdriver, remove the screw securing the intrusion switch module.
3. Lift the intrusion switch module out of the system.
Figure 25. Removing the intrusion switch module
Next steps
Replace the intrusion switch.

Installing the intrusion switch

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the air shroud.
After working inside your
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.
system.
Installing and removing system components 33