3. Connect the serial COM port cable to the serial port.
Figure 71. Installing the Serial COM port
Next steps
1.
Install the expansion card
2.
Replace the air
shroud.
3. Follow the procedure listed in
BOSS S1 card
Removing the M.2 BOSS riser
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
Hold the blue touch points, and lift the M.2 BOSS riser from the riser connector on the system board.
68
Installing and removing system components
riser.
After working inside your
Safety
instructions.
Before working inside your
system.
system.