Vga Module; Removing The Vga Module - Dell EMC XC Core XC450 Installation And Service Manual

Figure 83. Installing the system battery
Next steps
1. If applicable, install the expansion card riser
2. Follow the procedure listed in
3. Confirm that the battery is operating properly, by performing the following steps:
a. Enter the System Setup, while booting, by pressing F2.
b. Enter the correct time and date in the System Setup Time and Date fields.
c. Exit the System Setup.
d. To test the newly installed battery, remove the system from the enclosure for at least an hour.
e. Reinstall the system into the enclosure after an hour.
f. Enter the System Setup and if the time and date are still incorrect, see

VGA module

This is a service technician replaceable part only.

Removing the VGA module

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Remove the front bezel.
4. Remove the backplane
5. Remove the air shroud.
6. Disconnect the VGA cable from the VGA connector on the system board. For locating the connector, see the
jumpers and connectors
NOTE: Ensure that you note the routing of the cables as you remove them from the system board. Route the cable
properly when you replace it to prevent the cable from being pinched or crimped
78 Installing and removing system components
and connect the cables to the expansion card(s).
After working inside your
Safety instructions.
Before working inside your
cover.
section.
system.
Getting help
system.
section.
System board