2. Follow the procedure listed in
Front mounting front PERC module
This is a service technician replaceable part only.
Removing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3.
Remove the drive backplane
4. If installed,
Remove the air
5. Disconnect all the cables, observe the cable routing.
Steps
1. Using a Phillips #2 screwdriver, loosen the thumbscrews on the front PERC module.
2. Pull the front PERC module to disengage from the connector on the drive backplane.
3. Tilt and lift the front PERC module out of the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 80. Removing the front mounting front PERC module for 4x3.5-inch system
Next steps
Replace the front mounting PERC
Installing the front mounting front PERC module
Prerequisites
1. Follow the safety guidelines listed in the
After working inside your
Safety
instructions.
Before working inside your
cover.
shroud.
module.
Safety
instructions.
system.
system.
Installing and removing system components
75