Installing The Serial Com Port - Dell EMC XC Core XC450 Installation And Service Manual

Figure 69. Installing the PCIe blank
Next steps
Replace the serial COM port.

Installing the serial COM port

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. Lift the expansion card rsier
Steps
1. Remove the screws, lift the PCIe blank, and then open the latch on the expansion card riser. (Riser 1, Riser 2c).
Figure 70. Removing the PCIe blank
2. Slide and lock the serial COM port into the expansion card riser.
Safety instructions.
Before working inside your
from the connector on the system board.
system.
Installing and removing system components 67