Table of Contents
Advertisement
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
2. Align and insert the right control panel in the slot on the system.
3. Connect the right control panel cable to the connector on the system board.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 96. Installing the right control panel
Next steps
1.
Replace the air
shroud.
2.
Replace the backplane
3.
Replace the front
bezel.
4. Follow the procedure listed in
92
Installing and removing system components
cover.
After working inside your
system.
Hide quick links:
Advertisement
Table of Contents
