Optional Boss S1 Card; Removing The M.2 Boss Riser; Installing The M.2 Boss Riser - Dell EMC PowerEdge GPH2C Installation And Service Manual

Optional BOSS S1 card

Removing the M.2 BOSS riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
Steps
Hold the blue touch points, and lift the M.2 BOSS riser from the riser connector on the system board.
Figure 76. Removing the M.2 BOSS riser
Next steps
Replace the M.2 BOSS riser.

Installing the M.2 BOSS riser

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
1. Align the M.2 BOSS riser connector with the connectors on the system board and the guide on the M.2 BOSS riser with the
guiding slot on the system board.
2. Lower the M.2 BOSS riser into place until the M.2 BOSS riser connector is fully seated in the connector.
76 Installing and removing system components
Safety instructions.
Before working inside your
Safety instructions.
Before working inside your
system.
system.