Paper Cannot Be Cut; The Printer Does Not Go On; Roll Paper Cannot Be �Nserted �Nto The Paper Feed Slot; Cannot Load Sheets - Canon imagePROGRAF IPF9100 User Manual

Other problems

Paper cannot be cut

In the printer driver, No or Print Cut Guideline is
specied in Auto Cut .
In MAIN MENU , Eject or Manual is specied in
Cutting Mode .
The Cutter Unit is not installed.
Rolls are not cut when you are using the Media
Take-up Unit .

The printer does not go on

The printer is unplugged.
The specied voltage is not supplied.
Roll paper cannot be inserted into the Paper Feed Slot
The roll paper is warped.

Cannot Load Sheets

The paper source selection is incorrect.
758 Troubleshooting
Cause
Cause
Cause
Cause
Corrective Action
Specify Yes in Auto Cut in the printer driver.
Specify Automatic in Cutting Mode in MAIN MENU .
Install the Cutter Unit .
(→P.703)
Either execute Paper Cutting in the Control Panel or
lift the Release Lever and cut the roll with scissors.
(→P.237)
Corrective Action
Plug the power cord into the outlet, and then turn on
the printer.
Check the voltage of the outlet and breaker.
For information on the specied voltage, see
"Specications". (→P.133)
Corrective Action
Straighten out curls and reload the roll.
Corrective Action
Press the Feeder Selection button to activate the
Cut Sheet lamp .