Maintenance; Changing The Cutting Tool - YILMAZ DC 550 Operator's Manual

11. MAINTENANCE, SERVICE AND REPAIR

11.1 Maintenance

11.1.1 Remove the electric and pneumatic ( if any ) power connections of the machine.
11.1.2 Clean all surfaces of the machine from burs, chips and foreign substances. If the
machine will not be used for a long time, lubricate undyed parts with oil that
prevents rusting.
11.1.3 When cleaning the machine, do not use materials that may damage the dye.
11.1.4 Control cutting tools against corrosion, distortion and fractions. If cutting tools are
damaged, change them.
11.1.5 Before using cutting tool, operate the machine out of gear and control whether it is
inserted correctly, it is without flexure and it is inserted appropriately. Do not use
cutting tools that are damaged or lost its functionality.
11.2 Changing the Saw Blade
11.2.1 Use protective gloves when replacing Saw.
11.2.2 Cut the electric connection of the machine.
11.2.3 Take the M10 screw outside by rotating in the direction of counter clockwise with
8 mm Allen switch. ( Hold with 17 two-edged switch from the side in the saw axle
of which switch edge is opened )
11.2.4 Remove the connection parts of cutting set in the right order.
11.2.5 Remove the saw carefully.
11.2.6 Mount the saw by being sure that the rotation direction onto the axle is true.
11.2.7
Replace all removed parts in the same order.
11.2.8
By holding the M10 Allen screw by 8mm Allen switch and the saw axle simultaneously by
17 switches tighten in the direction of clockwise.
11.2.9
The saw selection should be made proper to EN 847-1 Standard.
123