Maintenance, Service And Repair; Maintenance; Changing The Cutting Tool - YILMAZ SC 550P User Manual

8. MAINTENANCE, SERVICE AND REPAIR

8.1 Maintenance

8.1.1 Cut the electric and pneumatic (if any) power connections of the machine.
8.1.2 Clean all surfaces of the machine from burs, chips and foreign substances. If the machine will not be used for a
long time, lubricate undyed parts with oil that prevents rusting.
8.1.3 When cleaning the machine, do not use materials that may damage the dye.
8.1.4 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them..
8.1.5 Before using cutting tool, operate the machine out of gear and control whether it is inserted correctly, it is
without flexure and it is inserted appropriately. Do not use cutting tools that are damaged or lost its functionality.
8.1.6 If the sawteeth are blunted, change immediately with a new / sharpened saw.
8.1.7 Sharpen with proper sharpening machines by taking the angular value of the saw into consideration.

8.2 Changing the cutting tool

8.2.1 Use
8.2.2 Cut the electric connection of the machine.
8.2.3 Fix the saw switch (Picture 12 NO: 28) to flange and head as shown in the picture (10-12 Picture NO: 25-20)
8.2.4 Take the M10 screw (Figure 15 159 number) outside by rotating in the direction of counter clockwise with 8mm
Allen switch. (Hold with 17 two-edged switch from the side in the saw axle of which switch edge is opened)
protective gloves when replacing Saw
46