11. MAINTENANCE, SERVICE AND REPAIR
11.3 Replacing the Motor Belt
Remove the bolt that fastens the belt housing cover and remove the cover.
Loosen the motor mounting screws by using a wrench.
After the motor mounting screws are loosened, tension of the belt will be reduced by moving the
motor forwards or backwards and then the belt will be removed.
Install a new belt in place of one that you have removed.
Motor Mounting
After installing the new belt, tighten the tensioning spindle by turning it clockwise by using a no. 8
allen wrench and tension the belt.
Retighten the motor screws after tensioning the belt ( FIGURE – 49 )
Finally,complete belt replacement operation by fastening the belt housing cover
FIGURE – 48
Screw
FIGURE – 49
Belt
Tesioning
Spindle
Belt Protection
Cover Screw
FIGURE – 50
124