YILMAZ DC 550 Operator's Manual page 105

7. OPERATION
7.8.6.1 Position :
7.8.6.2 Positioning Offset :
used during calibration of the machine. Calibration procedure is explained separately.
7.8.6.3 Saw Thickness :
here.
7.8.6.4 Saw Run-Out Value :
course of time, + or - values can be entered here to indicate the tolerance.
7.8.6.5 Serial Cut Fire Share :
little more in the head the can enter required value here.
7.8.6.6 Com Port :
here.
7.8.6.7 Font :
7.8.6.8 Com Port On Off :
No barcodes can be printed when it is turned off. If necessary, USB can be plugged and
this port can be turned off and the printer can be operated by means of the USB. Com
port is used as factory setting.
7.8.6.9 mm / inch adjustment:
on this page and switch to the
first. By pressing
activated.
The value shown here indicates the current position of the machine.
It indicates the position of the machine on the zero point. It is
The tooth thickness of the saw installed to the machine is written
Number of the port where the barcode printer is connected is entered
It is intended only for reading purposes; no modifications are allowed.
Turns the port on or off where the barcode printer is connected.
Should the servo drives switch to alarm mode, the drives are reset by pressing this
button.
It opens the page where factory settings are made. Access requires password and
it is used by service personnel.
The machine will be moved to the reference point when this button is pressed.
It opens the page where angle offset settings are made. Password is required for
that. Required password is ( 1234 )
If the saw installed on the machine causes run-out in the
When slicing in serial cutting mode, If you want to clean a
To make the dimensions in inches, click on
mode. To do this, the password must be entered
button enteren 1234 password and the button is
104
button