7. OPERATION
7.9.2 Serial Cutting Process Free at a Fixed Size ( 45 Degrees )
If you want to do a series cut at a fixed angle, cut-off mode from the list should be turned off. It goes
into free mode for this.
Here, cutting is done at a fixed length of 600 mm and at 45 degrees. The cutting process is
automatically terminated when the number entered is complete or the raw material size is exhausted.
7.9.3 Serial Cutting Process Free at a Fixed Size ( 135 [-45] Degrees )
600
This cut is the same as fixed 45 degrees in the mode, only the cutting angles are set to 135 (-45)
degrees. It is shown in the picture below.
The settings are made as follows:
600
600
600
112
600