Maintenance, Service And Repair; Maintenance; Changing The Cutting Tool - YILMAZ KD 350 M Manual

will not be fixed to the slot in the sub-levels. Tighten the special clamping screw after you turn the head at the
level you want.
7.3.4 Carry out the cutting operation after.

8. MAINTENANCE, SERVICE AND REPAIR

8.1 Maintenance

8.1.1 Cut the electric and pneumatic (if any) power connections of the machine.
8.1.2 Clean all surfaces of the machine from burs, chips and foreign substances. If the machine will not be used for a
long time, lubricate undyed parts with oil that prevents rusting.
8.1.3 When cleaning the machine, do not use materials that may damage the dye.
8.1.4 Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
8.1.5 Before using cutting tool, operate the machine out of gear and control whether it is inserted correctly, it is
without flexure and it is inserted appropriately. Do not use cutting tools that are damaged or lost its functionality.

8.2 Changing the cutting tool

8.2.1 Cut the electric connection of the machine.
8.2.2 Dismantle the blade guard group (FIGURE 2 N0.47) in the stipulated order.
8.2.3 Remove the segment (FIGURE 2 NO.96) on the protection sheet bar (FIGURE 2 NO.42). Set the end of the
protection sheet bar to off-position by removing it from the pin.
47