Advertisement
7.3 Angular cutting
7.3.1 Loosen the special clamping screw (FIGURE 2 NO.89) on set square (FIGURE 1 NO.25)
7.3.2 Pull the spring shaft (FIGURE 1 NO.23) from spring slot. At the same time, get the head (FIGURE 1 NO.33) at
the level you want with the aid of plastic arm (FIGURE 1 NO.64) with your other hand. You can read the angle
values with the aid of level reader (FIGURE 1 NO.17) on the plate (FIGURE 1 NO.33).
7.3.3 15- 22.5- 30 and 45 degrees can be set with the aid of spring (FIGURE 1 NO.23) and other sub degrees can be
set with the aid of special clamping screw (FIGURE 2 NO.89) on the set square (FIGURE 1 NO.25). The spring
will not be fixed to the slot in the sub-levels. Tighten the special clamping screw after you turn the head at the
level you want.
7.3.4 Carry out the cutting operation after.
8. MAINTENANCE, SERVICE AND REPAIR
8.1 Maintenance
8.1.1 Cut the electric and pneumatic (if any) power connections of the machine.
8.1.2 Clean all surfaces of the machine from burs, chips and foreign substances. If the machine will not be used for a
long time, lubricate undyed parts with oil that prevents rusting.
8.1.3 When cleaning the machine, do not use materials that may damage the dye.
8.1.4
Control cutting tools against corrosion, distortion and fractions. If cutting tools are damaged, change them.
8.1.5 Before using cutting tool, operate the machine out of gear and control whether it is inserted correctly, it is
without flexure and it is inserted appropriately. Do not use cutting tools that are damaged or lost its functionality.
48
Advertisement
