YILMAZ DC 550 Operator's Manual page 108

7. OPERATION
 The help of a miter slightly tighten or loosen the bolts, in the red marked area, to adjust the angle with
the help of a miter ( FIGURE – 45 ).
 Having completed the 90 degree adjustments, set the head angle to 45 degree using valves situated
behind the machine ( FIGURE – 44 ).
 Obtain a miter to adjust 45 degree ( FIGURE – 46 ).
 Check that the angle between machine table and saw is 90 degree. In case angle is different than 90
degree, adjust the angle as described in 90 degree adjustment ( FIGURE – 45 ).
 After angle adjustments, check cutting dimensions.
FIGURE – 44
FIGURE – 46
TESTERE AYAR GÖNYESİ
SAW ADJUSTMENT SETSQUARE
ПИЛА РЕГУЛИРОВКА УГОЛЬНИК
FIGURE – 45
107