Remote Chassis; Switching A Wavelength To An Optical Interface In The Same Chassis - Juniper PTX3000 IPLC Features Manual
Packet transport router integrated photonic line system
Hide thumbs
Also See for PTX3000 IPLC:
- Quick start manual (48 pages) ,
- Hardware manual (174 pages) ,
- Quick start manual (37 pages)
Table of Contents
Advertisement
CHAPTER 5
Switching Wavelengths on the IPLC to
Optical Interfaces in a Local or Remote
Chassis
Switching a Wavelength to an Optical Interface in the Same Chassis
Copyright © 2018, Juniper Networks, Inc.
Switching a Wavelength to an Optical Interface in the Same Chassis on page 27
Switching a Wavelength to an Optical Interface on a Remote Chassis on page 28
Configuring the Integrated Photonic Line Card to Switch Wavelengths to Local or
Remote Optical Interfaces on page 29
This topic describes how to configure the IPLC to switch the wavelengths on the
and
ports to compatible optical interfaces on the local chassis.
DROP
NOTE:
For a list of compatible optical interfaces that are compatible with
the IPLC ports, see
Before you begin, complete the following tasks:
Install the optical interface cards and configure the wavelength on the local optical
interface so that it is compatible with the wavelength on the IPLC. See
10-Gigabit or 100-Gigabit Ethernet DWDM Interface Wavelength
Install the IPLC module and connect the
optical interfaces.
To configure the IPLC to add or drop a wavelength to an optical interface on the local
chassis:
Specify the slot of the local IPLC module and access the IPLC configuration hierarchy.
1.
[edit]
user@host# edit chassis fpc slot
For example, if the IPLC base module resides in slot 1:
[edit]
user@host# edit chassis fpc 1 optical-options
PTX Series IPLC Compatibility
and
ADD
DROP
optical-options
ADD
.
Configuring the
.
ports to the respective local
27
Advertisement
Table of Contents
Troubleshooting
