Example: Configuring The Optical Supervisory Channel; Example: Configuring The Optical Supervisory Channel For The Integrated Photonic Line System And Optical Inline Amplifier - Juniper PTX3000 IPLC Features Manual

CHAPTER 9
Example: Configuring the Optical
Supervisory Channel
Example: Configuring the Optical Supervisory Channel for the Integrated Photonic
Line System and Optical Inline Amplifier
Requirements
Overview
Copyright © 2018, Juniper Networks, Inc.
Example: Configuring the Optical Supervisory Channel for the Integrated Photonic Line
System and Optical Inline Amplifier on page 73
This example shows you how to configure optical supervisory channel (OSC)
communication across the PTX3000 integrated photonic line system when you are using
the Juniper Networks optical ILA in the amplifier chain.
Requirements on page 73
Overview on page 73
Configuration on page 74
Configuring the PTX3000 Integrated Photonic Line System at Site B on page 78
Verification on page 78
This example uses the following hardware and software components:
Two PTX3000 Packet Transport Routers with the Integrated Photonic Line System
installed and running Junos OS Release 17.1 or later.
Three optical inline amplifiers.
Before you configure the optical supervisory channel, be sure you have:
Installed and configured the integrated photonic line system in the PTX3000 router
and that you are able to pass optical traffic end to end over the three optical ILAs.
This example shows you how to configure optical supervisory channel (OSC)
communications on the PTX3000 integrated photonic line system when using the optical
ILA in the amplifier chain.
73