Juniper PTX3000 IPLC Features Manual page 58

PTX3000 Integrated Photonic Line System Feature Guide
42
user@router% cli
[edit]
user@router# run request chassis fpc optical-module amplifier-chain ila
firmware-upgrade fpc-slot 5 ila-number 2
Upon completion, the following message displays on the Junos OS CLI:
Firmware upgrade command was successfully issued to the requested ILA
Verify that the upgrade process is complete on the optical ILA by issuing the following
4.
command:
user@router# run show chassis fpc optical-properties amplifier-chain ila summary
fpc-slot 5 ila-number 2
ILA Number
ILA Name
ILA Position
OSC IP Address
10.0.0.13/255.255.255.0
Manufacture Name
Manufacture Date
Part Number
Serial Num
Calibration Date
Firmware Version
Hardware Version
FPGA Version
X86CPLD Version
Board CPLD Version
System Date
System Time
Up Time
IP v4 Address/Mask/Gateway
192.168.7.136/255.255.0.0/ 192.168.7.254
OSC MAC Address
Board Temperature (C)
Temperature Threshold High/Low (C)
Power and Fan Plug Status (Fan 0/1/2, Power 0/1)
Fan2: 1 Power0: 0 Power1: 1
Fan Speed (Fan 0/1/2)
System Mode (auto/manual)
Firmware Upgrade Status (none/in progress/done)
Percent: 100
The last line of the output must indicate 100 percent complete as follows:
Firmware Upgrade Status (none/in progress/done)
100
Reset the optical ILA.
5.
user@router# run request chassis fpc optical-module amplifier-chain ila soft-reset
fpc-slot 5 ila-number 2
Reset command was successfully issued to the requested ILA
2
ILA-2
3
oplk
2016-04-07
EDFA128ILAJUP01
3D2L6140005
2016-04-07
2.10.0001
2.01
5.0
28
41
2015-09-22
18:43:03 GMT+0000
2363
aa:bb:cc:dd:ee:02
33.6
55.0/-5.0
Fan0: 1 Fan1: 1
9984 / 9984 / 9984
Auto
Status: Successful
Status: Successful Percent:
Copyright © 2018, Juniper Networks, Inc.