Configuring The Ip Address Of An Optical Inline Amplifier - Juniper PTX3000 IPLC Features Manual
Packet transport router integrated photonic line system
Hide thumbs
Also See for PTX3000 IPLC:
- Quick start manual (48 pages) ,
- Hardware manual (174 pages) ,
- Quick start manual (37 pages)
Table of Contents
Advertisement
Chapter 6: Configuring the Optical Supervisory Channel in the Amplifier Chain When Using the Optical Inline Amplifier
Configuring the IP Address of an Optical Inline Amplifier
Copyright © 2018, Juniper Networks, Inc.
To enable optical supervisory channel (OSC) communications and manage optical inline
amplifiers (ILA)s in the amplifier chain through the Junos CLI, you need to configure each
optical ILA with a unique IP address. This address is used for OSC communications to
and from the anchor IPLC, as well as for configuring certain optical ILA parameters through
the Junos OS CLI. Use this procedure when you are using the PTX3000 integrated photonic
line system with the optical ILA to enable OSC communication across the optical network
or to enable management of certain optical ILA parameters through the Junos OS CLI.
TIP:
Remember that all communication to and from an optical ILA is through
the anchor IPLC, so when you configure any options on an optical ILA, you
must specify the FPC number in which the anchor IPLC resides.
NOTE:
To configure any other optical ILA options, use the login procedures
describe in the
Before you begin, make sure you complete the following tasks:
Configure the IP address of the anchor IPLC. See,
1.
Anchor IPLC" on page 35
Configure the MAC address of the anchor IPLC. See,
2.
of the Anchor IPLC" on page 36
Configure the IPLC as the anchor in the amplifier chain. See,
3.
IPLC of the Amplifier Chain" on page 34
Configure a unique identification number for the optical ILA. See
4.
Optical ILA Identification Number" on page 37
To configure the IP address of the optical ILA:
Specify the slot in which the IPLC resides and access the IPLC amplifier chain
1.
configuration hierarchy.
[edit]
user@host# edit chassis fpc fpc-slot
For example:
[edit]
user@host# edit chassis fpc 3 optical-options amplifier-chain
Specify the IP address for the optical ILA interface.
2.
[edit chassis fpc 3 optical-options amplifier-chain]
user@host# set ila 1 ila-options ila-ipv4-address 10.0.0.11/24
Optical Inline Amplifier Hardware Guide
optical-options amplifier-chain
.
"Configuring the IP Address of the
"Configuring the MAC Address
"Configuring the Anchor
"Configuring the
39
Advertisement
Table of Contents
Troubleshooting
