Switching A Wavelength To An Optical Interface On A Remote Chassis - Juniper PTX3000 IPLC Features Manual

PTX3000 Integrated Photonic Line System Feature Guide
Related
Documentation

Switching a Wavelength to an Optical Interface on a Remote Chassis

28
Specify the wavelength number and the name of the physical optical interface to
2.
which you want to switch the wavelength.
[edit chassis fpc 1 optical-options]
user@host# set wavelength
For example, if you want to switch wavelength 1550.12 running on the local IPLC
module in slot 1 to the optical interface in slot 3, PIC 0, port 0:
[edit chassis fpc 1 optical-options]
user@host# set wavelength 1550.12 switch et-3/0/0
This step creates the association between the wavelength on the IPLC and the local
optical interface.
Verify that the configuration is correct. For example:
3.
[edit chassis fpc 1 optical-options]
user@host# show
wavelength 1550.12 {
switch {
et-3/0/0;
}
}
If the configuration is correct, save it.
4.
[edit chassis fpc 1 optical-options]
user@host# commit
Switching a Wavelength to an Optical Interface on a Remote Chassis on page 28
Understanding How to Configure the Integrated Photonic Line Card on page 9
Understanding the Integrated Photonic Line Card Architecture on page 6
This topic describes how to configure the IPLC module to switch a wavelength on the
and ports to a compatible optical interface on a remote chassis.
ADD DROP
NOTE: For a list of compatible optical interfaces that are compatible with
the IPLC ports, see
Before you begin, complete the following tasks:
Install the optical interfaces and configure the wavelength number on the interface so
that it is compatible with the wavelength number on the IPLC. See
10-Gigabit or 100-Gigabit Ethernet DWDM Interface Wavelength
Install the IPLC module at the remote location and connect the
to the respective remote optical interfaces.
nm switch interface-name
PTX Series IPLC Compatibility
Copyright © 2018, Juniper Networks, Inc.
.
Configuring the
.
and ports
ADD DROP