Dmoving The Tx Block Marker; Dtx Picture Set - Icom ID-52A Advanced Manual

14
SHARE PICTURES FUNCTION
Sending the picture

DMoving the TX block marker

You can select the block to start sending�
L While sending a picture, you cannot move the TX block
marker�
1� Push D-pad() to select the TX Picture zone, and
then push [ENT]�
2� Push [QUICK]�
3� Select "TX Picture Block Select�"
4� Rotate [DIAL] or push D-pad to move the TX block
marker�
L To move the TX block marker back to 1st block, push
[QUICK], and then select "BACK TO 1ST�"
5� Push [ENT]�
6� To close the TX PICTURE screen, push [MENU]�

DTX PICTURE SET

This screen is used to set a picture, size, quality, and
its intended destination to send�
L While sending a picture, you cannot change the settings�
1� Push D-pad() to select the TX Picture zone, and
then push [ENT]�
2� Push [ENT] again�
3� Select the setting item�
4� Select an option�
5� To close the TX PICTURE SET screen, push
[MENU]�
TIP: You can set each item to its default by pushing
[QUICK], and then selecting "Default" on the Quick
Menu window�
TX Picture
Select the picture to send, saved in the "Picture" folder
("ID-52" > "Picture") on the microSD card�
L When you set the TX Picture in the TX PICT HISTORY
screen, "(RE TX)" is displayed before the file name�
Picture Size
Set the desired size of a picture to send to "160 x
120," "320 x 240," or "640 x 480�"
L You cannot select a size larger than the size of the
picture�
Picture Quality
Set the quality of a picture to send to "Low (25%),"
"Standard (50%)," or "High (75%)�"
Receiver
Enter the receiver's call sign to let all stations that receive
the picture know the picture's intended destination�
NOTE: All stations that receive the signal can see
the picture, even if they are not set as the receiver�
14-6
(Default: 320 x 240)
(Default: Standard (50%))
(Default: -----)