Control Console - Toro Reelmaster 3105-D Operator's Manual

•
The cutting units only operate when the
mow/transport slide is in the M
•
The cutting units do not lower when the
mow/transport slide is in the T
Tilt-Steering Lever
Pull the tilt-steering lever
steering wheel to the desired position. Then push the
lever forward to secure the position.

Control Console

1. Cutting-unit shift lever
2. Cutting-unit drive switch
3. Oil-pressure light
4. Engine coolant
temperature light
5. Hour meter
6. Glow-plug indicator light
Cutting Unit Shift Lever—Raise/Lower
•
To lower the cutting units to the ground, push
forward the cutting unit shift lever forward to the
L position (Figure
OWER
Note:
The cutting units do not lower unless the
engine is running. You do not need to hold the
lever in the forward position while the cutting units
are lowered.
•
To raise the cutting units, pull the shift lever
rearward to the R
AISE
Note:
The reels do not run while the cutting units
are raised.
Cutting Unit Drive Switch
The cutting unit drive switch
positions: E and D
NGAGE
operates a solenoid valve on the valve bank to drive
the cutting units.
position.
OW
position.
RANSPORT
(Figure 40) back to tilt the
Figure 41
7. Throttle
8. Alternator light
9. Ignition switch
10. Lift lever lock
11. Parking brake
41).
position.
(Figure 41) has 2
. The rocker switch
ISENGAGE
Oil Pressure Warning Light
The oil pressure warning light
engine oil pressure drops below a safe level.
Engine Coolant Temperature Warning Light
The temperature warning light
if the engine coolant temperature is high. At this
temperature, the cutting units shut off. If the coolant
temperature rises another 5.5°C (10°F), the engine
shuts off to prevent further damage.
Hour Meter
The hour meter
machine operation. The hour meter starts to function
whenever the key switch is on.
Glow-Plug Indicator
The glow-plug indicator light
when the glow plugs are energized.
Throttle
Move the throttle
engine speed and rearward to decrease the engine
speed.
g373744
Alternator Light
The alternator light
engine runs. If the alternator light illuminates while the
engine runs, check the charging system and repair
it as necessary.
Ignition Switch
Use the ignition switch
and lights. The ignition switch has 3 positions:
•
The S O
HUT
•
The R /P
UN
run or preheats the cylinder head of the engine.
•
The S
TART
Note:
When the key is in the R
the glow plug energizes and the indicator light
illuminates for approximately 7 seconds.
Lift Lever Lock
Move the lift lever lock
the cutting units from dropping.
Parking Brake
Whenever the engine is shut off, engage the parking
brake (Figure 41) to prevent accidental movement of
the machine. To engage the parking brake, pull up
on the lever; to disengage the brake, push down the
lever.
27
(Figure
(Figure
(Figure 41) indicates the total hours of
(Figure
(Figure 41) forward to increase the
(Figure 41) shuts off when the
(Figure 41) to run the engine
position shuts off the engine.
FF
position allows the engine to
REHEAT
position energizes the starter.
/P
UN
(Figure 41) rearward to prevent
41) glows if the
41) illuminates
41) illuminates
position,
REHEAT