Table of Contents
Advertisement
Proline Prosonic Flow 91
"
!
!
Endress+Hauser
9.8
Return
Caution!
Do not return a measuring device if you are not absolutely certain that all traces of hazardous
substances have been removed, e.g. substances which have penetrated crevices or diffused through
plastic.
Costs incurred for waste disposal and injury (burns, etc.) due to inadequate cleaning will be charged
to the owner-operator.
The following steps must be taken before returning a flow measuring device to Endress+Hauser,
e.g. for repair or calibration:
• Always enclose a duly completed "Declaration of contamination" form. Only then can
Endress+Hauser transport, examine and repair a returned device.
• Enclose special handling instructions if necessary, for example a safety data sheet as per
EC REACH Regulation No. 1907/2006.
• Remove all residues. Pay special attention to the grooves for seals and crevices which could
contain residues. This is particularly important if the substance is hazardous to health, e.g.
flammable, toxic, caustic, carcinogenic, etc.
Note!
You will find a preprinted "Declaration of contamination" form at the back of these Operating
Instructions.
9.9
Disposal
Observe the regulations applicable in your country!
9.10
Software history
Date
Software
version
02.2010
V 1.01.XX
04.2006
V 1.00.00
Note!
An upload or download between the individual software versions is only possible with a special
service software.
Changes to software
New Prosonic Flow W Sensor types
Original software
Troubleshooting
Operating
Instructions
71109049/02.10
71024989/04.06
59
Advertisement
Table of Contents
