Drive Setup - gefran ADL500 Quick Start Up Manual, Specification And Installation

9.1 DRIVE SETUP

DRIVE SETUP, which is a procedure that is presented to the user only when the drive is first turned on, allows all
the files required for the user's needs and the type of system to be imported.
If setup has been completed but the user wishes to see it again, it is necessary to execute the Load default procedure
(PAR 580).
All the setup parameters are also available in the different drive menus.
The setup steps are as follows:
● Load language
● Load application
● Load parameters from USB (ADL550 and ADL530)
● Set encoder parameters
● Select Motor from USB (ADL550 and ADL530)
When the drive is first switched on:
Boot ver. 0.3.0
Step 1 – Load language
01 /05
Language select
English
Value:
Set the language to be used to program the drive (default English).
Press ▼ to go to the next step or press E to change the selection.
Options available: (0) English, (1) Italian, (2) French, (3) German, (4) Spanish, (8) Turkish.
Step 2 – Load application
02 /05
Load application
EFC
Value:
Set the application to be used by the drive (default EFC).
Press ▼ to go to the next step or press E to change the selection.
Options available: (1) EFC, (2) EPC, (3) DCP, (4) CAN417.
Step 3 – Load parameters from USB
For ADL550 and ADL530 only.
03 /05
Load par from USB
Press E to execute
Transfer the parameters from the memory connected to the drive's USB port.
Press ▼ to go to the next step or press E to load the parameters from USB.
62
DRIVE SETUP
ADL500
Access setup ?
Starting up
E=Yes
PAR: 578
0
PAR: 390
1
PAR: 594
ADL500 • Quick installation guide - Specifications and connection
E
Esc=No
See step 1
See step 2
See step 3
See step 4
See step 5