Serial Interface (Pc Connector); Drive/Rs485 Port Point-To-Point Connection - gefran ADP200 Quick Start Up Manual, Specification And Installation

7.4 Serial interface (PC connector)

The ADP200 drive is provided with a port as standard (9-pin D-SUB receptacle connector) for connection of the RS485
serial line used for drive-PC point-to-point or multipoint communication (with the GF-eXpress configuration software).
Note!
The port is not galvanically isolated. The OPT-RS485-ADP option must be used If galvanic separation is required.

7.4.1 Drive/RS485 port point-to-point connection

A twin-pair consisting of two symmetrical conductors, spiral wound with a common shield plus the bonding connection
cable, connected as shown in the figure, must be used for connection. The transmission speed is 38.4 kBaud.
For connection of the RS485 serial line to the PC, see the figure below.
PIN
PC
1
2
3
4
5
6
7
5 1
8
9 6
9
Reserved
RS485
5 4
9 8
EQP
Figure 7.5.1: Serial connection (not isolated)
A)
RS485
Shielded cable with connectors,
5 mt (8S864C)
B)
RS485
Optional
PC-OPT-ADP
Shielded cable with connectors,
(S5L85)
5 mt
C)
RS485
Shielded cable with connectors,
5 mt (8S864C)
D)
RS485
Shielded cable with
RS485
connectors,
5 mt (8S864C) PCI-COM (S560T)
Kit (S50T6) = Shielded cable 5 mt + PCI-COM
Figure 7.5.2: RS485 connection to the PC
ADP200 • Quick installation guide - Specifications and connection
Function I/O Elect. Interface
- - -
- - -
A I/O RS485
EQP - RS485
0V (Ground) - Supply
+5V - Supply
B I/O RS485
0V (Ground) - Supply
DIR O RS485
TxA/RxA
TxB/RxB
PE
2 1
3
7 6
RS232
RS485
PCI-COM (S560T)
(8S864C)
RS232
RS485
PCI-COM (S560T)
USB
RS232
RS232
USB RS232 converter
(S5A20)
O = Output, I/O = Input/ Output
+5 V
RS485
Industrial PC
(with RS485)
41