Use Of The Optional Keypad (Kb-Adl500); Description; Membrane Keypad; Meaning Of Leds - gefran ADL500 Quick Start Up Manual, Specification And Installation

8. Use of the optional keypad (KB-ADL500)

This section describes the optional KB-ADL500 programming keypad (cod. S5P11T) and how to use it (display and
programming parameters).
Note !
For the connetion refer to section "7.6 Optional Keypad interface (RJ45 connector)" on page 41.

8.1 Description

8.1.1 Membrane keypad

This section describes the keys on the membrane keypad and their functions
Symbol
ESC
SAVE
FIND
RST
CUST
DISP
E





8.1.2 Meaning of LEDs

LEDs
BRK
CNT
EN
ILIM
N=0
AL
→
BRK
01 STARTUP WIZARD
Drive status indicator LEDs
02 OPTIMIZATION WIZAR
03 TROUBLESHOOTING
04 DRIVE
→
Membrane keypad
Reference Description
Returns to the higher level menu or submenu. Exits a parameter, a list of parameters, the list of the last 10 parameters and the
Escape FIND function.
Can be used to exit a message that requires use of this.
Salva Saves the parameters directly in the non-volatile memory without having to use PAR 550 Save parameters
Trova
Enables the function for accessing a parameter using its number. To exit these functions, press the
Reset Resets alarms, only if the causes have been eliminated.
Custom
Displays the last 10 parameters that have been modified. To exit these functions, press the
Display Displays a list of drive functioning parameters.
Enters the submenu or selected parameter, or selects an operation. It is used when modifying parameters to confirm the new
Enter
value that has been set.
Moves the selection up in a menu or list of parameters.
Up
During modification of a parameter, increases the value of the digit under the cursor.
Moves the selection down in a menu or list of parameters.
Down
During modification of a parameter, decreases the value of the digit under the cursor.
Left Returns to the higher level menu. During modification of a parameter, moves the cursor to the left.
Right Accesses the submenu or parameter selected. During modification of a parameter, moves the cursor to the right.
Meaning of LEDs
The LED is lit when the drive has activated the brake release command
The LED is lit when the drive has activated the close contactors command
The LED is lit during IGBT modulation (drive operating)
When this LED is lit the drive has reached a current limit condition. During normal functioning, this LED is off.
The LED is lit when motor speed is 0.
The LED is lit when the drive signals that an alarm has been triggered
ADL500 • Quick installation guide - Specifications and connection
CNT EN ILim n=0 AL
ESC DISP
E
SAVE CUST
RST
FIND
←
128 x 64 dot liquid crystal graphic display, with amber backlighting.


key.
key.
51