Replacing The Battery - Omron F160 Setup Manual

Maintenance
5.
6.
Precaution
CHECK
5-2-2

Replacing the Battery

The F160 contains a battery that backs up the time and date information.
When the battery is nearly discharged, the message "BATTERY LOW" will be
displayed at startup. Replace the battery with an OMRON 3Z49-BAT1 Battery.
Dispose of the spent battery properly.
CHECK
SeeAlso
Replacement Procedure
1.
2.
3.
4.
All manuals and user guides at all-guides.com
Remove the Light from the Camera.
Reverse steps 1 through 4 when installing the Lens and Light.
Do not disassemble the Lens. Disassembly can damage the Lens.
When you want to use the Camera alone without connecting an Intelligent
Lighting, use M2 × 3 screws in the bottom of the Camera instead of the
long screws removed in step 4. The screws removed in step 3 are not
needed.
• Always turn OFF the power supply before replacing the battery.
• The F160's clock will be reset if the new battery is not connected within 2
minutes of removing the spent battery.
If the clock is inadvertently reset, the time and date will have to be set
again.
Refer to the Conversational Menu Operation Manual or the Expert Menu
Operation Manual for details.
Open the battery cover on the side of the F160. The cover can be opened
with a small flat-blade screwdriver.
F 1 6 0
PO W
ER VI SI O
N M AT
C O N
R U N E
TR O
LL ER
ER R
O R
C O N
SO LE
C AM
ER A
0
C A M
E R A
1
The battery is mounted to the inside of the battery cover. Hold the battery
connector by its base and pull it off.
2.
F 1 6 0
PO W
ER VI SI O
N M AT
C O N
R U N TR O E
LL ER
ER R
O R
C O N
SO LE
C AM
ER A
0
C A M
E R A
1
Cut the binding band that secures the battery and remove it from the cover.
Reverse steps 1 through 3 to install the new battery. Use the new binding
band included with the new battery to attach it to the battery cover.
3.
Binding band
Section 5-2
43