Christie J Series Setup Manual page 36

Section 4: Maintenance
Table 4.1
Projector Part Number
Roadster S+18K-J
Mirage S+18K-J
Roadster HD16K-J
Mirage HD16K-J
Roadster S+22K-J
Mirage S+22K-J
Roadster HD20K-J
Mirage HD20K-J
Roadster WU20K-J
Mirage WU20K-J
Matrix WU20K-J
1. TURN THE LAMP OFF
Press the power to switch the lamp off. Allow the cooling fans to stop automatically (within 5 minutes) before
proceeding with step 2.
handling.
2. UNPLUG THE PROJECTOR
When the cooling fans have stopped, turn the main switch of the projector off, then unplug the projector.
3. REMOVE THE LAMP MODULE
Using a #2 Phillips screwdriver, loosen the two (2) lock screws securing the lamp door, which is located at the
rear of the projector below the Input panel. See
4-2
Projector Model
132-013116-xx
132-013127-xx
132-014117-xx
132-014128-xx
132-016119-xx
132-016120-xx
132-017110-xx
132-017121-xx
132-018111-xx
132-018122-xx
132-018133-xx
NOTE: This wait period is required to allow the lamp to sufficiently cool before
Always power down and unplug the projector prior to servicing. Allow the lamps to
cool before handling.
Protective gear required. Wear a face shield.
Lamp Type
2.4 kW
3.0 kW
Figure 4-1.
F 4-1
IGURE
Lamp/Filter Kit Required
03-900518-xx
003-000306-xx
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)