Christie J Series Setup Manual page 38

Section 4: Maintenance
7. INSERT THE NEW LAMP MODULE
Align the base plate of the new lamp module under both side alignment guides
module into the projector in the same orientation you removed the old lamp module until the resistance
increases. NOTE:
provided to indicate the fully seated position.
8. SECURE THE INSERTION/REMOVAL LEVER
Secure the insertion/removal lever by threading the know into the threaded block by hand or using a Phillips
screwdriver. See
9. CLOSE THE LAMP DOOR
Using a Phillips screwdriver, secure the lamp door.
4-4
A slightly harder push may be required to ensure it is fully seated. Lamp alignment marks are
Figure 4-5.
F 4-4
IGURE
F 4-5
IGURE
(Figure 4-4) then slide the
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)