Christie J Series Setup Manual page 37

Hide thumbs Also See for J Series:

Table of Contents

4. UNSCREW HANDLE

Unscrew the knob on the insertion/removal handle either by hand or using a Phillips screwdriver. See

5. REMOVE THE LAMP MODULE

Make sure the lamp insertion/removal handle hook is located behind the lamp module

lamp module off of electrical terminal by pulling on the insertion/removal handle. Carefully pull on the lamp

module handle to remove the lamp. If the lamp is to be discarded, follow safe disposal/recycling procedures.

6. RECORD THE SERIAL NUMBER OF THE NEW LAMP

In the lamp menu, select CHANGE LAMP. This will prompt for the old lamp serial number (if previously not

entered). Enter the new lamp serial number.

accurate lamp statistics to be archived.

J Series 2.0, 2.4, and 3.0 kW Setup Guide

020-100751-01 Rev. 1 (10-2011)

4-2

IGURE

4-3

IGURE

NOTE:

This action is not mandatory, it is recommended for

Section 4: Maintenance

Figure 4-

(Figure

4-3) and pull

4-3

Table of Contents