Christie J Series Setup Manual page 16

Section 2: Installation and Setup
3. Insert the plug fully on to the receptacle. When fully inserted, the cap on the AC plug will rest against the
side of the projector
4. Reinsert the locking pin into the bracket surrounding the AC receptacle by pressing down on the button on
the end of the locking pin and insert the pin into the bracket, as shown in
STEP 5 - Power up
After the AC Power has been switched on, the LCD display above the keypad indicates "Please wait" and the 4
LED status indicators at the rear of the projector will be solid amber.
The projector has reached standby and is ready for use when:
• The LCD displays "Standby mode"
• The Status LED is solid amber
• The Lamp LED is off
To turn on the projector, do one of the following:
• Press and hold the power button on either the built-in keypad or the remote control
• Press the power button twice (quickly) on either the built-in keypad or the remote control
Thereafter; the lamp and fans will power on and a green LED will start scrolling back and forth indicating that
the projector is in warm up mode.
The projector is on and ready to display video when the lamp LED and the status LED are both solid green.
NOTE: See 3 Operation
NOTE: If the projector has a stepper motor lens mount installed and the inserted lens has never been
calibrated, there will be a short period where the projector calibrates all of the lens motors (zoom, focus,
horizontal, and vertical) by moving them through their full range of motion.
2-6
(Figure 2-8).
Do not attempt operation if the AC supply and cord is not within the specified ratings.
On power down, wait 5 minutes for the fans to turn OFF before unplugging the
projector. Always switch off the projector before unplugging the AC line cord.
for a full description of the status indicators.
F 2-8
IGURE
Figure 2-8.
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)