Christie J Series Setup Manual page 14

Section 2: Installation and Setup
• Video Decoder Input Card, depending on the source you can apply the following;
• Composite video source to 1-CVBS, using a BNC Cable
input is selected as CVBS.
• Component input grouping is selected in the projector menu.
• A component signal on Inputs 4(Pr), 5(Y), 6(Pb) using BNC Connectors.
input, YPbPr.
• S-Video to one of the two, 2-SVID or 3-SVID using S-Video cable.
• S-Video using two BNC cables, with Luma (Y) connected to 4 (Sy) and Chroma (C) connected to 6 (Sc).
NOTE: Must be grouped as 1 S-Video + 1 CVBS.
• DMX512 Interface Card, has two 5pin XLR connectors - 1 (input) male and 1 (output) female. If there is
active communications on the DMX512 Interface card the power LED will blink between low intensity and
high intensity.
STEP 4 - Connecting the Line Cord
IMPORTANT!
To prevent the line cord from inadvertent disconnection, perform one of the following steps:
For 1900W and 2400W Models
1. Connect the line cord of the projector to the AC receptacle at the AC inlet of the projector, then push the
wire clip over the plug to retain it, as shown in
2-4
Use the line cord provided with the projector.
listed on the license label, located at the back of the projector.
NOTE: Same signal can be used on 4, 5 or 6 when
NOTE:
Figure 2-5.
F 2-5
IGURE
NOTE: Grouped as a component
Voltage and current requirements are
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)