Christie J Series Setup Manual page 15

For 3000W Model
1. Remove the locking pin from the bracket surrounding the AC receptacle at the AC inlet of the projector by
pressing down on the button on the end of the locking pin, and then pull upwards on the pin to remove it,
as shown in
2. Open the cap on the AC plug and line up the slot on the plug with the pin on the receptacle. See
J Series 2.0, 2.4, and 3.0 kW Setup Guide
020-100751-01 Rev. 1 (10-2011)
Figure 2-6.
F 2-6
IGURE
F 2-7
IGURE
Section 2: Installation and Setup
Figure 2-7.
2-5