Maintenance; Cleaning The Spectrometer And Power Supply Units - PerkinElmer RamanMicro 300 Series Getting Started Manual

92 . RamanMicro 300 Getting Started Guide

Maintenance

The system does not require regular maintenance other than occasional checking and
cleaning.

Cleaning the Spectrometer and Power Supply Units

Switch off the mains voltage and disconnect the mains cord before
cleaning.
WARNING
You can clean the outside of the spectrometer using a soft, lint-free cloth, moistened if
required with a little water. Mild detergent may be used, if necessary. Do not use abrasive or
solvent-based cleaning materials. Always perform a patch test on an inconspicuous area
before you clean the entire instrument.
Avoid spilling liquid into the instrument or accessories. Clean all external spills immediately. If
anything that is spilled enters the main body of the spectrometer, make the instrument
inoperative and then contact a PerkinElmer Service Engineer.
Do not directly clean electrical contacts.
WARNING
To avoid any electrical shock hazards, do not allow liquids to run down
into the external PSU. Also, do not allow liquids to run into the
spectrometer. Only use a soft, dry cloth to clean the spectrometer or the
PSU.
WARNING
Removal of the protective housing or exterior panels on any instrument
or accessory will allow potentially hazardous Class 3B laser radiation to
be emitted and will invalidate the instrument warranty.
WARNING