PerkinElmer RamanMicro 300 Series Getting Started Manual page 79

Table 3 Recommended experimental setup
Parameter
Scan time
(Experiment page/Set-up tab)
Number of scans
(Experiment page/Set-up tab)
Spectral Information Range
(Experiment page/Advanced tab)
Spectral Information Data Interval
(Experiment page/Advanced tab)
Background Handling -
Number of Background Scans
(Experiment page/Advanced tab)
Background Handling -
Renew background at start of each sample
(Experiment page/Advanced tab)
Sampling Area
(Experiment page/Sampling tab)
Sampling Type
(Experiment page/Sampling tab)
Accessory Configuration –
Sample accessory and Sample holder
(Instrument page/Hardware tab)
Accessory Configuration - Beam path
(Instrument page/Hardware tab)
Video Preview
(Video Preview page)
Spectral Preview
(Spectral Preview page)
Using the RamanMicro 300 . 79
Recommended Set Up
5 seconds (sample dependant)
5 (sample dependant)
-1
140–3200 cm
-1
2 cm (default)
5 (the recommendation is that this should
be same as Number of scans, and a
minimum of 1)
Yes
Select the number and style of sampling
points
If applicable, select Spacing and No. of
points
Select the type Sample accessory and
Sample holder
Designated sample output
You can set the sample position using the
cross hair alignment.
You can monitor the spectrum of your
sample.