Assembly Of The Ramanmicro 300; Fitting The Stage On The Microscope - PerkinElmer RamanMicro 300 Series Getting Started Manual

Assembly of the RamanMicro 300

The Olympus BX51 microscope is designed to enable you to analyze microscopic samples.
You can purchase a manual stage or a motorized stage.
To prevent potential injury to yourself and damage to the instrument,
switch OFF all components in the system and disconnect them from the
line power supply before you perform any of the procedures described
in this section.
WARNING

Fitting the Stage on the Microscope

To fit the stage:
1. Unpack the stage from the shipping material.
2. Remove the objective nosepiece from the microscope.
3. Carefully locate the stage above the stage support ring and then lower the stage into
position.
4. Ensure that the stage is level, and then fasten the stage in position by tightening the
screw at the front of the stage (Figure 11).
Fixing screw
Figure 11 Fitting the stage
5. Replace the objective nosepiece.
If you have a manual stage, you can upgrade to a motorized stage at any time. For more
information contact your PerkinElmer representative.
Installing Your RamanMicro 300 . 39