Installation Procedure - PerkinElmer RamanMicro 300 Series Getting Started Manual

Installation Procedure

NOTE: If you are installing a new system, with a RamanStation 400, the whole of this
procedure will be carried out as part of setting up your RamanStation 400
instrument; refer to the
If you are installing a new system, with a RamanFlex 400, steps 1 to 36 of this
procedure, installing the Spectrum and Raman Instrument software, will be carried
out as part of setting up your RamanFlex 400 instrument; only installation of the
camera drivers, steps 37 onwards, is required.
If you are upgrading an existing system with a RamanMicro 300, you will require the
assistance of a PerkinElmer Service Engineer to upgrade various configuration files.
The Installation Wizard helps you install the software on your PC.
NOTE: It is important to note that you must be logged on at Administrator level on Windows
before installing the software.
Spectrum Software CD
1. Place your
The Spectrum software must be version 6.3.2 or later.
2. If the installation program does not start automatically, from the Start Menu select Run.
The Run dialog is displayed.
3. Enter d:\Setup.exe and then click OK.
Replace d:\ with the drive letter for your CD.
The InstallShield Wizard dialog appears while the system is preparing to install the
software.
RamanStation 400 Series Getting Started Guide
into your CD drive.
Installing Your RamanMicro 300 . 47
for details.