Attaching The Illumination Source - PerkinElmer RamanMicro 300 Series Getting Started Manual

42 . RamanMicro 300 Getting Started Guide

Attaching the Illumination Source

To attach the illumination source to the illuminator module:
1. Hold the illumination source in position against the rear of the illuminator module.
2. Using the allen key supplied (Figure 15), fasten the two screws so that the source is
supported.
3. Connect the black cable from the illumination source to the microscope frame.
Power cable
Figure 15 Attaching the illumination source to the microscope
Top View
Screws
Allen key
Screws