Introduction - Dataman 448PRO2 User Manual

DATAMAN-48PRO2 / DATAMAN-48PRO2C

Introduction

DATAMAN-48PRO2 is a super fast universal USB/LPT interfaced universal programmer built
to meet the strong demand of the small manufacturing and developer's community for the fast
and reliable universal programmer.
DATAMAN-48PRO2C is a cost effective version of DATAMAN-48PRO2 programmer (without
some special devices and LPT port interface). If you need program some of the mentioned
devices, please take a look at DATAMAN-48PRO2 programmer.
DATAMAN-48PRO2 / DATAMAN-48PRO2C support all kinds of types and silicon
technologies of today and tomorrow programmable devices without family-specific module.
You have freedom to choose the optimal device for your design. Using built-in in-circuit serial
programming (ISP) connector, the programmer is able to program ISP capable chips in circuit.
DATAMAN-48PRO2 / DATAMAN-48PRO2C aren't only programmer, but also tester of
TTL/CMOS logic ICs and memories. Furthermore, it allows generating user-definable test
pattern sequences.
DATAMAN-48PRO2 / DATAMAN-48PRO2C provide very competitive price coupled with
excellent hardware design for reliable programming. It is probably best "value for money"
programmer in this class.
DATAMAN-48PRO2 / DATAMAN-48PRO2C provide super fast programming due to high-
speed FPGA driven hardware and execution of time-critical routines inside of the programmer.
It is at least fast than competitors in this category, for many chips much faster than most
competitors. As a result, when used in production this one-socket-programmer waits for an
operator, and not the other way round.
DATAMAN-48PRO2 / DATAMAN-48PRO2C interfaces with the IBM PC Pentium compatible
or higher, portable or desktop personal computers through USB (2.0/1.1) port or any standard
parallel (printer) port (except DATAMAN-48PRO2C). Programmer can utilize power of both
USB high-speed port and IEEE1284 (ECP/EPP) high-speed parallel port. Support of both
USB/LPT port connections gives you the choice to connect the DATAMAN-48PRO2
programmer to any PC, from latest notebook to older desktop without USB port.
DATAMAN-48PRO2C has only USB interface but after upgrade to DATAMAN-48PRO2, also
high-speed IEEE 1284 (ECP/EPP) printer-port (LPT) interface is available (LPT port
connection usage is disabled in software only).
DATAMAN-48PRO2 / DATAMAN-48PRO2C provides a banana jack for ESD wrist straps
connection to easy-to-implement the ESD protection control and also other banana jack for
earth wire.
DATAMAN-48PRO2 / DATAMAN-48PRO2C have a FPGA based totally reconfigurable 48
powerful TTL pindrivers, where provide H/L/pull_up/pull_down and read capability for each pin
of socket. Advanced pindrivers incorporate high-quality high-speed circuitry to deliver signals
without overshoot or ground bounce for all supported devices. Improved pindrivers operate
down to 1.8V so you'll be ready to program the full range of today's advanced low-voltage
devices.
31