Connecting Dataman-40Pro To Pc; Manipulation With The Programmed Device - Dataman 448PRO2 User Manual

Table of Contents

Advertisement

6. USB connector for PC
7. Power supply connector
Note: Due to low power consumption of DATAMAN-40PRO in inactive state, it doesn't require
power switch. When the power LED indicator glows with a low intensity the DATAMAN-40PRO
is in inactive mode.

Connecting DATAMAN-40PRO to PC

Recommendation for connecting programmer to PC:
1. make ground connection between programmer and PC or other ground
2. connect programmer with PC via USB cable
3. connect power supply to programmer
Problems related to the DATAMAN-40PRO
and their removing
If you have any problems with DATAMAN-40PRO
Common notes please.

Manipulation with the programmed device

After selection of desired device for your work, you can insert into the open ZIF socket (the
lever is up) and close socket (the lever is down). The correct orientation of the programmed
device in ZIF socket is shown on the picture near ZIF socket on the programmer's cover. The
programmed device is necessary to insert into the socket also to remove from the socket when
LED BUSY light off.
Warning: DATAMAN-40PRO programmer hasn't protection devices, which protect the content
of programmed device against critical situations, for example power failures and PC failure
(interrupted cable...). Moreover, a device is usually destroyed in the programming mode due to
forced interruption of the control program run (Reset or switching the computer off) due to
removing the connecting cable, or unplugging the programmed device from the ZIF socket.
Incorrectly placed device in the ZIF socket can cause its damage or destruction.
DATAMAN-40PRO communication cable
Power supply connector
+
49
DATAMAN 40PRO
PC interconnection,
PC interconnection, see section

Advertisement

Table of Contents
loading

This manual is also suitable for:

48pro248pro2c40pro

Table of Contents