Connecting Dataman-448Pro2 To The Pc; Manipulation With The Programmed Device; In-System Serial Programming By Dataman-448Pro2 - Dataman 448PRO2 User Manual

7. power supply connector
8. power switch
9. "GND" connector can be used for grounding of the programmer
"ESD wrist strap" connector is place for attaching of ESD wrist strap
10. temperature controlled fans
11. type B USB connector for PC

Connecting DATAMAN-448PRO2 to the PC

Recommendation for connecting programmer to PC:
1. make ground connection between programmer and PC or other ground
2. connect programmer with PC via USB cable
3. connect power supply to programmer and turn on by power switch "8".

Manipulation with the programmed device

After selection of desired device for your work, you can insert it into the open ZIF socket (the
lever is up) and close socket (the lever is down). The correct orientation of the programmed
device in ZIF socket is shown on the picture near ZIF socket on the programmer's cover. The
programmed device is necessary to insert into the socket also to remove from the socket when
LED BUSY light off.
Note: Programmer's protection electronics protect the target device and the programmer itself
against either short or long-term power failures and, partly, also against a PC failure. However,
it is not possible to grant the integrity of the target device due to incorrect, user-selected
programming parameters. Target device may be not destroyed by forced interruption of the
control program (reset or switch-off PC), by removing the physical connection to the
programmer, but the content of actually programmed cell may remains undefined. Don't unplug
the target device from the ZIF socket during work with devices (LED BUSY shine).
In-system serial programming by
DATAMAN-448PRO2
Optimized advanced pindriver deliver programming performance without overshoot or ground
bounce for all device technologies. Pin drivers operate down to 1.8V so you'll be ready to
program the full range of today's advanced low- voltage devices.
The ISP programming solution performs programming verification at the marginal level of
supply voltage, which, obviously, improves programming yield, and guarantees long data
retention.
DATAMAN-448PRO2 communication cable
20