Table of Contents
Advertisement
Main
Sub
Category
Category
Ks/H
1.8.c
Maximum rate of turn (°/sec)
1.9.r
Maximum deviation of bearing servo (°)
A-1 cont.
1.A.F
Maximum deviation of horizontal servo (°)
1.b.S
Bearing offset A (°)
2.1.o
A-2
Bearing offset B (°)
2.2.O
73
Parameter/description
of movement (v/°).
This parameter is only used for GC85.
Suspension wire twist torque. Fixed value.
Maximum rate of turn in the turn rates which the
bearing servo system followed up to this moment
(°/sec).
NOTE: The maximum is measured after 3 hours from
system start.
NOTE: Reset this data after completion of installation!
Maximum deviation value in the bearing servo loop
that occurred up to this moment (°).
NOTE: The maximum is measured after 3 hours from
system start.
NOTE: Reset this data after completion of installation!
Maximum deviation value in the horizontal servo loop
that occurred up to this moment (°).
NOTE: The maximum is measured after 3 hours from
system start.
NOTE: Reset this data after completion of installation!
Offset value included in the "master bearing" and
used for correction of fixed error (°). If the Master
compass cannot be mounted parallel to the vessel's
fore-after line, this parameter is used to compensate
for a small mounting error.
1
Value for general bearing error correction to enter to
Master compass bearing. It is used to correct the
bearing if the bearing for some reason deviates from
correct heading.
This value is cleared when it passes the zero-cross pin
or when power is switched OFF.
1
This value is cleared at the time of zero crossing pin passage and a power
supply OFF.
ADVANCED SETTINGS
Default
Range
value
1.477
1.000 - 2.000
0.00
-
0.00
-
0.00
-
0.0
0.0 - 359.9
0.0
0.0 - 359.9
988-12720-002
Advertisement
Table of Contents
