Table of Contents
Advertisement
Simrad GC80/85 Dual MK2 Gyro Compass
Main
Sub
Category
Category
Zero-cross bearing (°)
2.3.h
Zero-cross error allowance (°)
2.4.E
Year
2.5.y
Month and Day
2.6.N
Hour and Minute
2.7.t
A-2 cont.
Total days of operation
2.8.d
Display/setting of GPS connection
2.9.G
Display/setting of LOG connection
2.A.L
Display/setting of LOG (serial) connection
2.b.S
988-12720-002
Parameter/description
Absolute bearing set for MCU board when zero-cross
pin was passed during start-up sequence (last
azimuth operation) and normal running operation.
Zero-cross bearing can be set in this menu, but is
normally set up by measuring position (angle) of the
zero-cross pin in the Master compass by the test
mode A.
Zero-cross alarm limit. The compass will generate a
zero cross alarm when the difference between the
zero-cross bearing and the relative bearing exceeds
this zero cross value.
This value should be set every time the zero-cross pin
is detected.
Used to set current year.
Used to set current month and date.
Used to set current hour and minute.
This value should be reset after the installation is
completed.
The following abbreviations are used:
bE:
GPS connected
Non: No GPS connected
NOTE: When this value is set to "Non", GPS cannot
be selected as the vessel's input for speed
and latitude.
The following abbreviations are used:
bE:
with Log (contact)
Non: No Log (contact)
NOTE: When this value is set to "Non", LOG cannot
be selected as the vessel's speed input.
The following abbreviations are used:
bE:
with Log (serial)
Non: No Log (serial)
Default
Range
value
345.3
0.0 - 359.9
2.0
0.0 - 5.0
-
2000 - 2099
-
-
-
-
-
-
-
bE or Non
-
bE or Non
-
bE or Non
74
Advertisement
Table of Contents
