Input Specifications - Simrad GC80 Dual MK2 User Manual

Simrad GC80/85 Dual MK2 Gyro Compass
8.3

Input specifications

988-12720-002
Serial input signal (GPS)
Circuits: ......................................................................................................... 1
Electrical: .................................................................... RS422/NMEA0183
Baud rate: ..................................................................................... 4800 bps
Data bits: .............................................................................................. 8 bits
Parity: ..................................................................................................... None
Stop bits: ...................................................................................................... 1
Transmit freq.: ................................................................................ 1 - 5 Hz
Input format:
$--GGA,x,xx.x,N,xx.x,E,x,~*hh<CR><LF> *
$--GLL,xxxx.xx,N,xxxx.xx,E~*hh<CR><LF>
$--VTG,xx,T,xx,M,xx.x,N,xx,K*hh<CR><LF>
$--ZDA,xxxxxx.xx,xx,xx,xxxx,xx,xx*hh<CR><LF>
* Priority
Serial input signal (External heading)
Circuits: ......................................................................................................... 1
Electrical: .................................................................... RS422/NMEA0183
Baud rate: ....................................................................... 4800/38400 bps
Data bits: .............................................................................................. 8 bits
Parity: ..................................................................................................... None
Stop bits: ...................................................................................................... 1
Transmit freq.: ........................................................... 1-5 0 Hz/20-50 Hz
Input format:
$--HDT,xxx.x,T*hh<CR><LF>
$--THS,xxx.x,a*hh<CR><LF>
$--ROT,x.x,a*hh<CR><LF>
$--HDG,xxx.x,xx.x,a,xx.x,a*hh<CR><LF>
Input data format must be the same as selected output
data format from the Control unit (HDT/THS). When
powered ON, the Gyro will automatically detect the
external sensor's baud-rate.
Serial input signal (LOG)
Circuits: ......................................................................................................... 1
Electrical: .................................................................... RS422/NMEA0183
Baud rate: ..................................................................................... 4800 bps
Data bits: .............................................................................................. 8 bits
Parity: ..................................................................................................... None
Stop bits: ...................................................................................................... 1
Transmit freq.: ............................................................................... 1-50 Hz
Input format:
$--VBW,x.x,x.x,A,x.x,x.x,A~*hh<CR><LF>
80