51
Activating an external heading sensor
If an external heading sensor is connected to the GC80/85 system, the
following switches have to be set to enable the external heading sensor:
-
DIP switch no.5 on S1 on both SCC boards.
-
DIP switch no.1 (and 2) on S1 on the SCOIF board.
-
DIP switch no.3 (and 4) on S1 on the PCC board (on the back side of
the Dual MK2 control panel).
For a complete list of DIP switch settings, refer to DIP SWITCH SETTINGS,
page 113.
SCC boards
For location of the boards, refer the figure on the previous page.
No external sensor
INSTALLATION
Active external sensor
988-12720-002