Table of Contents
Advertisement
65
4
When Gyro is selected and the numbers are flashing, press the
ARROW buttons to increase/decrease the latitude value and
confirm the entry with the ACK/ENT button.
-
This entered latitude value is used, together with speed and
bearing information, to calculate the vessel's current latitude.
5
The display will return to show latitude value without flashing.
Setting the Speed input source
When the system is configured as described in Configuring the Sensitive
element page 63 onwards, the speed input source can be changed as
described below:
1
Press the DISP button until the display shows speed value and
speed input source.
2
Press the SET button once, and the upper line in the display starts
flashing.
3
Use the ARROW buttons to toggle between available speed input
sources:
Manual
GPS
LOG (pulse)
LOG (serial)
4
Select active speed input source and confirm the selection by
pressing the ACK/ENT button.
INSTALLATION
988-12720-002
Advertisement
Table of Contents
