Tristar 3000, Asap 2000, And Asap 2010 Sample Tubes; Inserting Adapters - Micromeritics SmartPrep 065 Operator's Manual

SmartPrep

TriStar 3000, ASAP 2000, and ASAP 2010 Sample Tubes

Adapters for these sample tubes are included as a standard accessory with the
SmartPrep. Additional adapters may be ordered if needed (refer to Chapter 5 for
ordering information).
Sample tubes and heating station adapters may be very hot. Wear the
proper gloves and hold the sample tube by the upper part of its stem.
Hold the isothermal type of adapter by its handle. Failure to observe
these precautions may result in severe burns.
Do not place your fingers inside the heating stations; the stations may be
hot enough to cause burns.

Inserting Adapters

1. Place the adapter over the sample tube.
Adapter Handle
2. Place the gas delivery tube in the sample tube (refer to Inserting Gas Deliv-
ery Tubes in Samples Tubes in this chapter).
Sep 98
Inserting and Removing Heating Station Adapters
Figure 2-8. Placing Adapter on Sample Tube
2-17